| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Insufficient resource pool in the ACME HTTP-01 challenge responder of Progressive Robot hMailServer 6.0.0 through 6.3.6 allows a remote unauthenticated attacker to cause a certificate issuance or renewal to fail. When the server obtains or renews a TLS certificate over ACME it runs an HTTP-01 challenge responder on port 80 for the certificate authority to read the challenge token; the responder served one connection at a time, accepting a socket, waiting up to five seconds to receive a request, answering it, and only then accepting the next. A client that connected and sent nothing held the single worker for the whole timeout, so enough idle connections during a validation keep the certificate authority's own request from being answered in time and the validation fails. Sustained across a certificate's renewals this leads to the certificate expiring, after which clients refuse the server's TLS; the mail service itself continues on its current certificate until then. No authentication is required to connect to the responder. Version 6.3.7 serves up to 64 connections at once and closes a connection past that, so that where a handful of idle connections, one after another, sufficed before, a client must keep 64 idle connections open at once throughout a validation to have the certificate authority's connection closed. |
| In the Linux kernel, the following vulnerability has been resolved:
fs/resctrl: Prevent use-after-free in rdtgroup_kn_put()
A struct rdtgroup is reference counted via rdtgroup::waitcount. Callers that
need the structure to remain valid across a sleep (while waiting on acquiring
rdtgroup_mutex) take a reference with rdtgroup_kn_get() and release it with
rdtgroup_kn_put().
The release path is intended to serve as the fallback freer: if the count
drops to zero and the group has already been marked RDT_DELETED,
rdtgroup_kn_put() frees the structure.
The bulk teardown paths free_all_child_rdtgrp() and rmdir_all_sub() resulting
from a resctrl directory remove or resctrl fs unmount act as the primary
freer: they hold rdtgroup_mutex and free each rdtgroup whose waitcount is
zero, otherwise they set RDT_DELETED and leave the freeing to the last waiter.
These two freers race. rdtgroup_kn_put() commits waitcount == 0 with
atomic_dec_and_test() outside rdtgroup_mutex, then reads rdtgroup::flags.
Between those two operations a concurrent caller of free_all_child_rdtgrp()
or rmdir_all_sub() (which holds the mutex) can observe waitcount == 0 via
atomic_read(), call rdtgroup_remove(), and kfree() the structure.
The subsequent read of rdtgroup::flags in rdtgroup_kn_put() is then
a use-after-free, and the structure may even be freed twice if the freed
memory happens to satisfy the RDT_DELETED flag check.
Replace the bare atomic_dec_and_test() with atomic_dec_and_mutex_lock() so
that the decrement-to-zero takes rdtgroup_mutex before the count becomes
globally visible. The inspection of rdtgroup::flags then runs under the same
mutex held by the bulk freers, making the two paths mutually exclusive.
The common case where the count does not reach zero remains lock-free. Defer
kernfs_unbreak_active_protection() until after the mutex is dropped since
kernfs active protections functionally wrap rdtgroup_mutex. Remove resource
group, which in turn drops its kernfs reference, after kernfs protection is
restored.
[ bp: Split the commit messsages into smaller, easier-parseable paragraphs. ] |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: fs/xattr: don't assume the inode is locked in path_unlink/path_rmdir
bpf_lsm_has_d_inode_locked() makes the verifier rewrite
bpf_[set|remove]_dentry_xattr() to the _locked variants, which assume
that the caller already holds the inode's i_rwsem. The path_unlink and
path_rmdir hooks are listed, but security_path_unlink() and
security_path_rmdir() run before vfs_unlink()/vfs_rmdir() take the
victim inode's i_rwsem, so a sleepable BPF LSM program attached to
either hook mutates the victim's xattrs without the lock held.
Drop the two path hooks from d_inode_locked_hooks so that the verifier
keeps the locking bpf_[set|remove]_dentry_xattr() variants, which take
the lock themselves. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: fix race l2cap_sock_cleanup_listen() vs. put_chan
For L2CAP sockets without owning sk->sk_socket, reading
l2cap_pi(sk)->chan may race against concurrent l2cap_sock_kill() ->
l2cap_sock_put_chan(). This excludes simultaneous proto_ops callbacks,
but access in l2cap_sock_cleanup_listen() has unsafe lockless read.
[Task 1] [Task 2 (hdev->workqueue)]
l2cap_sock_release(parent) l2cap_disconn_cfm
l2cap_sock_cleanup_listen l2cap_conn_del
bt_accept_dequeue l2cap_chan_del
lock_sock(sk) l2cap_sock_teardown_cb
bt_accept_unlink
bt_sk(sk)->parent = NULL
release_sock(sk) ----------------> lock_sock(sk)
parent = /* NULL */
lock_sock(sk) <--------------------- release_sock(sk)
sock_set_flag(sk, SOCK_ZAPPED)
l2cap_sock_close_cb
l2cap_sock_kill(sk)
l2cap_sock_put_chan
chan = READ l2cap_pi(sk)->chan l2cap_pi(sk)->chan = NULL
l2cap_chan_hold_unless_zero l2cap_put_chan(chan)
kref_get_unless_zero(&chan->ref)
Task 1 may observe NULL which causes null-ptr-deref.
Fix the race by taking lock_sock() in l2cap_sock_kill() to
synchronize with l2cap_sock_cleanup_listen(). hold_unless_zero() is not
needed here, l2cap_pi(sk)->chan owns reference if it is non-NULL.
Clarify code comments vs. locking. |
| In the Linux kernel, the following vulnerability has been resolved:
s390/debug: Fix deadlock during unregister
Unregistering an s390dbf debug area while one of the associated debugfs
files is being written to can cause a deadlock:
$ echo >.../vmur/level $ rmmod vmur
===================================================
debugfs write
debugfs_file_get()
debug_unregister()
mutex_lock(debug_mutex)
debugfs_remove()
wait for debugfs_file_put()
debug_file_ops.write()
debug_input()
mutex_lock(debug_mutex) ==> DEADLOCK
Fix this by splitting debug_unregister() into an s390dbf and debugfs
part, and running only the s390dbf part with debug_mutex locked. |
| A flaw was found in Samba's internal DNS server where unauthenticated TKEY registration requests were added to the TKEY name cache before being rejected. A remote, unauthenticated attacker can exploit this behavior by sending a large number of TKEY requests with arbitrary names, exhausting the cache and evicting legitimate TKEY entries. This can prevent legitimate TSIG authentication for signed DNS queries, resulting in a denial of service. |
| When Bidirectional Forwarding Detection (BFD) is configured in Static and Dynamic routing protocols, undisclosed traffic can cause the Traffic Management Microkernel (TMM) to stop processing BFD packets and cause the configured routing protocol to fail over. Note: Software versions which have reached End of Technical Support (EoTS) are not evaluated. |
| Insufficient resource pool in the core management mechanism for some Intel(R) Processors may allow an authenticated user to potentially enable denial of service via local access. |
| Insufficient Resource Pool vulnerability in Ethernet function of Mitsubishi Electric Corporation MELSEC iQ-R series CPU module, MELSEC iQ-L series CPU module, MELSEC iQ-R Ethernet Interface Module, MELSEC iQ-R CC-Link IE TSN Master/Local Module, CC-Link IE TSN Remote I/O Module, CC-Link IE TSN Analog-Digital Converter Module, CC-Link IE TSN Digital-Analog Converter Module, CC-Link IE TSN - CC-Link IE Field Network Bridge Module, CC-Link IE TSN - AnyWireASLINK Bridge Module, CC-Link IE TSN FPGA Module, CC-Link IE TSN Remote Station Communication LSI CP620 with GbE-PHY, MELSEC iQ-R Motion Module, MELSEC iQ-L Motion Module, MELSEC iQ-F FX5 Motion Module, MELSEC iQ-F Series CPU module, MELSEC iQ-F Series Ethernet module, MELSEC iQ-F Series Ethernet/IP module, MELSEC iQ-F Series OPC UA Module, MELSEC iQ-F Series CC-Link IE TSN master/local module, GOT2000 Series CC-Link IE TSN Communication Unit, FR-A800-E series inverters, FR-F800-E series inverters, FR-E800-E series inverters, INVERTER CC-Link IE TSN Plug-in option, INVERTER CC-Link IE TSN Safety Plug-in option, INVERTER CC-Link IE TSN communication function built-in type, MR-J5 series AC Servos MELSERVO, MR-JET series AC Servos MELSERVO, MR-MD333G series AC Servos MELSERVO, MR-JE series AC Servos MELSERVO, MELSERVO-J4 AC Servos MELSERVO and Embedded Type Servo System Controller allow a remote attacker to cause a temporary Denial of Service condition for a certain period of time in Ethernet communication of the products by performing TCP SYN Flood attack. |
| When a WF200/WGM160P device is configured to operate as an Access Point, it may be vulnerable to a denial of service triggered by a malformed packet. The device may recover automatically or require a hard reset. |
| An unauthenticated remote attacker can exploit a denial-of-service vulnerability in the device's web server functionality by sending a specially crafted HTTP request with a malicious header, potentially causing the server to crash or become unresponsive. |
| IBM Jazz Reporting Service could allow an authenticated user on the network to affect the system's performance using complicated queries due to insufficient resource pooling. |
| Insufficient resource pool in Windows Kerberos allows an unauthorized attacker to deny service over a network. |
| In mlflow/mlflow version 2.17.2, the `/graphql` endpoint is vulnerable to a denial of service attack. An attacker can create large batches of queries that repeatedly request all runs from a given experiment. This can tie up all the workers allocated by MLFlow, rendering the application unable to respond to other requests. This vulnerability is due to uncontrolled resource consumption. |
| Dell Wyse Management Suite, versions prior to WMS 5.1, contains an Insufficient Resource Pool vulnerability. An unauthenticated attacker with remote access could potentially exploit this vulnerability, leading to Denial of service. |
|
Dell PowerScale OneFS 8.2.x, 9.0.0.x - 9.4.0.x, contain an insufficient resource pool vulnerability. A remote unauthenticated attacker could potentially exploit this vulnerability, leading to denial of service.
|
| A denial of service vulnerability exists in the web server functionality of Moxa SDS-3008 Series Industrial Ethernet Switch 2.1. A specially-crafted HTTP message header can lead to denial of service. An attacker can send an HTTP request to trigger this vulnerability. |
| ChargePoint Home Flex Bluetooth Low Energy Denial-of-Service Vulnerability. This vulnerability allows network-adjacent attackers to create a denial-of-service condition on affected installations of ChargePoint Home Flex charging devices. Authentication is not required to exploit this vulnerability.
The specific flaw exists within the connection handling of the Bluetooth Low Energy interface. The issue results from limiting the number of active connections to the product. An attacker can leverage this vulnerability to create a denial-of-service condition on the system. Was ZDI-CAN-21455. |
| DietPi-Dashboard is a web dashboard for the operating system DietPi. The dashboard only allows for one TLS handshake to be in process at a given moment. Once a TCP connection is established in HTTPS mode, it will assume that it should be waiting for a handshake, and will stay this way indefinitely until a handshake starts or some error occurs. In version 0.6.1, this can be exploited by simply not starting the handshake, preventing any other TLS handshakes from getting through. An attacker can lock the dashboard in a state where it is waiting for a TLS handshake from the attacker, who won't provide it. This prevents any legitimate traffic from getting to the dashboard, and can last indefinitely. Version 0.6.2 has a patch for this issue. As a workaround, do not use HTTPS mode on the open internet where anyone can connect. Instead, put a reverse proxy in front of the dashboard, and have it handle any HTTPS connections. |
| Vulnerability in the MySQL Connectors product of Oracle MySQL (component: Connector/J). Supported versions that are affected are 8.0.32 and prior. Difficult to exploit vulnerability allows high privileged attacker with network access via multiple protocols to compromise MySQL Connectors. Successful attacks require human interaction from a person other than the attacker. Successful attacks of this vulnerability can result in unauthorized ability to cause a hang or frequently repeatable crash (complete DOS) of MySQL Connectors as well as unauthorized update, insert or delete access to some of MySQL Connectors accessible data and unauthorized read access to a subset of MySQL Connectors accessible data. CVSS 3.1 Base Score 5.3 (Confidentiality, Integrity and Availability impacts). CVSS Vector: (CVSS:3.1/AV:N/AC:H/PR:H/UI:R/S:U/C:L/I:L/A:H). |
